Industrial/Commercial, Expert Witness, Electrical Engineering, Electrical Engineer

12/02/10

Industrial/ Commercial Electrical Services -

In recent years because of the highly competitive nature of the business climate many Industrial firms (probably yours) have reduced staff in certain areas, including equipment specialists, electrical, mechanical and structural engineering, third party design reviews and forensic engineering. Under normal circumstance this is not a problem.

However, when unusual problems arise or plant changes are required for which your industrial firm does not have the expertise then it becomes a problem.

You can call on CCC to fill this gap on a just-in-time basis. CCC can act as your firm's engineering staff (or an extension of it) to allow you to concentrate on your core business. CCC can perform the work for you without your having to take on the permanent overhead of one or more experts in the areas listed below. CCC uses the SKM suite of software - DAPPER, CAPTOR, etc. to perform studies and analysis

System Design -

Integrated design including the following:

Develop System Design

Ensure Compliance with National and Local Standards

Ensure Constructability

Oversight and Review of Contractor charges

System Performance and Equipment Sizing -

Perform the following design calculations:

Running voltage and motor starting voltage drop calculations

Short circuit calculations including motor an generator contributions

Circuit breaker and fuse selection

Equipment sizing

Cable selection, sizing and installation

Arc flash hazard analysis

Energy Management for Commercial & Industrial Facilities-

Minimize energize use:

Identification of energy consuming devices

Choice of energy reduction methodology

Estimate of energy savings in $$

Application of technology to facility

Procedure/Process Review -

Optimize design deliverables:

Identification of required drawings

Defining drawing content

Choice of databases versus drawings

Application of technology to design process